Electra Elite IPK Document Revision 4Programming Manual 2 - 607______________________________________________________________________________________________________________________________________________________________________5-00 Digit Add/Del for Tie Line NetworkingAssignmentGeneral DescriptionUse this Memory Block to specify the number of digits to add/delete from thetelephone number sent from a distant system over Tie lines or from DID lines. Thedigits enable the system to determine whether a call is directed to the local system orto a distant system. Refer to Notes.DisplayProgramming Procedures1 Go off-line.2 Press LK5 to access the Memory Block.3 Press the corresponding CO/PBX line key to enter the data. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric dataD to go to the next Trunk Group No. Setting Data:000: No Addition or Deletion001~009: [1]~[9] Add010: [0] Digit Add100~199: [00]~[99} Add201: 1-Digit Delete202: 2-Digit Delete301~309: 1-Digit Delete and 1~9 Add310: 1-Digit Delete and 0 Add400~499: 1-Digit Delete and 00~99 Add501~509: 2-Digit Delete and 1 ~ 9 Add510: 2-Digit Delete and 0 Add600~699: 2-Digit Delete and 00 ~99 Add4 Press G to write the data and display Memory Block 5-01.5 After Memory Blocks 5-01~5-03 are programmed, the next Trunk Group No. is displayed on Memory Block 5-00.6 Program all Trunk Group Nos. Trunk Group No. 01 is displayed again.Trunk Group Mode5Submode—Data No.00PC Programming¦+ALN0 1 / 0 0 : A D D / D E L 0 0 0T I M E D I S P L A YTrunkGroup No.(01~32)DataNo. Title SettingData
