Electra Elite IPK Document Revision 4Programming Manual 2 - 207______________________________________________________________________________________________________________________________________________________________________1-8-01 SLT or Automated Attendant/DISA toCPU PBR SelectionGeneral DescriptionUse this Memory Block to specify whether the four Push Button Receiver (PBR)circuits in the CPUI( )-U( ) ETU are used for Single Line Telephones or AutomatedAttendant/Direct Inward System Access (DISA).DisplaySettings Notes LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 Default notassigned.PBR 1and 2PBR 3and 4Programming Procedures1 Go off-line.2 Press LK1 + LK8 to access the Memory Block.3 Press the corresponding CO/PBX line key to change the data option.The LED indication changes to indicate the data each time the CO/PBX line key is pressed.4 Press G to write the data. The next Memory Block is displayed.5 Program the next Memory Block or press E to go back on-line.When LK1 and LK2 are assigned to Automated Attendant/DISA, a PBR( )-U( ) ETU must be installed in thesystem when Single Line Telephones are used.System Mode1Submode8Data No.01PC Programming¦+BTI0 1 : P B R ( S L T / A A )T I M E D I S P L A YTitleDataNo.CO/PBXLine LED Off OnData Single Line Telephone A.A./DISAThe shaded areaindicates the defaultsetting.
