Electra Elite IPK Document Revision 4Programming Manual 2 - 487______________________________________________________________________________________________________________________________________________________________________3-65 Hold Tone Automated AttendantSelectionGeneral DescriptionUse this Memory Block to specify the Automated Attendant message that is played toan extension or DID trunk on an incoming call.DisplaySettingsPage 1LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8The shadedselection is thedefault.NONE MSG 1 MSG 2 MSG 3 MSG 4 MSG 5 MSG 6 MSG 7Page 2LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8MSG 8Programming Procedures1 Go off-line.2 Press LK3 + G + FE to access the Memory Block.3 Press line key to specify the Automated Attendant message to play to an extension or DID trunk on an incoming call to CO/PBXNo. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.C to go to the next pageA to go to the previous page4 Press G to write the selected data and display the next Memory Block.5 Program the next Memory Block or press E to go back on-line.CO/PBX Line Mode3Submode—Data No.65PC Programming¦+AU0 1 / 6 5 : I N C N O N E | 1T I M E D I S P L A YCO/PBXNo.(01~64)DataNo. TitleSettingData Page
