Electra Elite IPK Document Revision 4Programming Manual 2 - 277______________________________________________________________________________________________________________________________________________________________________1-10-07 Call by Call Service ParameterAssignmentGeneral DescriptionUse this Memory Block to specify the Service Parameters for each Route AdvanceBlock (RAB). This setting data is sent to the Service Parameters in the NSF-IE(Network Specific Facility Code-Information Element) when making outgoing calls.Service Parameter Assignment is an Identification Number that is assigned whensubscribing with the carrier for the different services.DisplayProgramming Procedures1 Go off-line.2 Press LK1 + LK10 + JG to access the Memory Block.3 Enter 1~5 digits for Setting Data using the dial pad. Use the following to enter data:JandLto move the cursorK~Ito enter dataD to select next RAB No. Setting Data No. 1 = 0 or 1 for each entry. Setting Data No. 2 = Three-digit code 000~127 for each entry.Default ValuesAll RABs 0~0004 Press G to write the data. Digit 2 is displayed.5 Repeat Steps 3 and 4 for each remaining digit for RAB 1. The next Memory Block is displayed.6 Program the next Memory Block or press E to go back on-line.System Mode1Submode10Data No.07PC Programming¦+AY0 1 / 0 7 : S P 1 = 0 – 0 0 0T I M E D I S P L A YDataNo.SettingData 2RAB01~32 TitleSettingData 11~5
