Electra Elite IPK Document Revision 4Programming Manual 2 - 289______________________________________________________________________________________________________________________________________________________________________1-11-00 T1 Signal Format SelectionGeneral DescriptionUse this Memory Block to specify the signal format of the T1 trunk connected to thesystem. The signal format used (12- or 24-Multiframe) depends on the channel serviceunit/demarcation (CSU/D mark) equipment being used.DisplaySettings Notes LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.12(SF)24(ESF)Programming Procedures1 Go off-line.2 Press LK1 + LK11 to access the Memory Block.3 Press the corresponding CO/PBX line key to change the data option. Setting Data:SF = Superframe Format (12-Multiframe)ESF = Extended Superframe Format (24-Multiframe)4 Press G to write the data. The next Memory Block is displayed.5 Program the next Memory Block or press E to go back on-line.Related ProgrammingM.B. Number Memory Block Name7-1 Card Interface Slot AssignmentThe DTI-U( ) ETU must be assigned in the system to set this Memory Block.System Mode1Submode11Data No.00PC Programming¦+AD0 1 / 0 0 : F R A M E = 2 4T I M E D I S P L A Y0 1 / 0 0 : F R A M E = 2 4T I M E D I S P L A YDataNo.SettingDataDTI No.(01~08) Title
