2 - 436 Memory Blocks___________________________________________________________________________________Document Revision 4 Electra Elite IPK___________________________________________________________________________________3-14 Tie Line Type AssignmentGeneral DescriptionUse this Memory Block to assign the loop supervision to be used for each Trunkassociated with a Tie line.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.2ND DIAL IMMEDIATE DELAY WINKProgramming Procedures1 Go off-line.2 Press LK3 + G + ADto access the Memory Block.3 Press the corresponding CO/PBX line key to change the loop supervision for CO/PBX No. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.4 Press G to write the data and display the next Memory Block.5 Program the next Memory Block or press E to go back on-line.Related ProgrammingM.B. Number Memory Block Name3-92 Trunk (Installed, DP/DTMF) SelectionCO/PBX Line Mode3Submode—Data No.14PC Programming¦+ALT0 1 / 1 4 : 2 N D D I A LT I M E D I S P L A YTie/DIDNo.(01~64)DataNo. Title
