13 Volumetric Line Leak Tests Leak Test Frequency13-2Leak Test FrequencyAs mentioned, when you select a leak test method—ALL LINES in this example—the system displays the message:You can now choose to run the line leak tests on a specific date, or you can run the tests on an annual, monthly,weekly, or daily basis.ON DATETo run the test on a specific date, press STEP in response to the ON DATE message. (To run the test annually,monthly, weekly, or daily, follow the procedures described in the appropriate section below.) The system displaysthe message:Press CHANGE, and enter the date on which you want the tests to run. Enter the date in the format MM/DD/YYYY. Press ENTER to confirm the date:Press STEP to continue. The system displays the START TIME message. Follow the procedure under “Leak TestStart Time” on page 13-4.ANNUAL TESTTo run the tests annually, press CHANGE and press ENTER in response to the ON DATE message:The system displays the message:Press STEP to continue setting the annual test. The system displays the message:To set the date of the annual test, press CHANGE until the month during which you want to perform the testappears, and press the Right Arrow key. Press CHANGE until the week during which you want to perform the testappears and press the Right Arrow key. Press CHANGE until the day on which you want to perform the testappears. Press ENTER to confirm the date:ALL LINES:ON DATETEST ON DATE: ALL LINESDATE: XX/XX/XXXXDATE: XX/XX/XXXXPRESS TO CONTINUEALL LINES:ON DATEANNUALLYPRESS TO CONTINUETEST ANNUALLY: ALL LINESJAN WEEK 1 MONMONTH WEEK DAYPRESS TO CONTINUE
