6 Communications Setup Auto-Dial Setup6-14To set the date of the weekly transmission, press CHANGE until the day on which you want to transmit the reportsappears. Press ENTER to confirm the date:Press STEP to continue. If you are using the All Phones method or have set up all the receivers for Single Phone,refer to the section entitled “Continue Communications Setup” on page 6-15. If you are using the Single Phonemethod and have additional receivers to set up, refer to the section entitled “Setting Up the Frequency forAdditional Receivers (Single Phone Only)” on page 6-15.AUTO-DIAL FREQUENCY: DAILYIf necessary, press STEP until you see the message:Press CHANGE four times and press ENTER. The system displays the message:Press STEP to display the message:Press CHANGE and enter the time at which you want to transmit the reports. Press the Right Arrow key to chooseAM or PM. Press ENTER to confirm your entry:Press STEP to continue. If you are using the All Phones method or have set up all the receivers for Single Phone,refer to the section entitled “Continue Communications Setup” on page 6-15. If you are using the Single Phonemethod and have additional receivers to set up, refer to the section entitled “Setting Up the Frequency forAdditional Receivers (Single Phone Only)” below.AUTO-DIAL FREQUENCY: BIR ENDIf necessary, press STEP until you see the message:Press CHANGE five times and press ENTER. The system displays the message:Press STEP to continue. The system displays the message:DAYPRESS TO CONTINUEALL RCVRSON DATEDAILYPRESS TO CONTINUEDAILY: ALL RCVRSTIME: DISABLEDTIME: (Time)PRESS TO CONTINUEALL RCVRSON DATEBIR ENDPRESS TO CONTINUEDIAL BIR END: ALL RCVRSTIME DISABLED
