6-156 Communications Setup Auto-Dial Alarm SetupTo enable this feature, press CHANGE:Press ENTER and the system confirms your choice with the message:Press STEP to continue.If you are using the All Phones method or have set up all the receivers for Single Phone, refer to the sectionentitled “Continue Communications Setup” on page 6-15. If you are using the Single Phone method and haveadditional receivers to set up, refer to the section entitled “Setting Up the Frequency for Additional Receivers(Single Phone Only)” on page 6-15.SETTING UP THE FREQUENCY FOR ADDITIONAL RECEIVERS(SINGLE PHONE ONLY)If necessary, press STEP until you see the message:Press STEP until you see the message:Press TANK/SENSOR to choose the destination (D1, D2, etc.) you want to set up. Choose the frequency youwant for this destination by following the appropriate Auto-Dial Frequency instructions, beginning on page 6-11.NOTE: Do not press ENTER after changing the destination. You must choose the Auto-Dial Frequency, asdescribed in the previous sections, before pressing ENTER.CONTINUE COMMUNICATIONS SETUPIf you are finished setting up the Auto-Dial Frequency, press STEP, if necessary, until you see the message:This screen displays for modem modules only. Press STEP to continue.Auto-Dial Alarm SetupIMPORTANT! Before you set up this feature, you must enter information for the In-Tank Setup function and set upall the sensors in your system. If an alarm occurs while you are setting up this feature and you have not set up in-tank and sensor information yet, the system will try to send a report. This action may cause a system lockout.If necessary, press STEP until you see the message:DIAL BIR END: ALL RCVRSTIME: AUTO DAILY CLOSINGTIME: AUTO DAILY CLOSINGPRESS TO CONTINUED1: RCVR REPORT LISTPRESS SINGLE RCVR: D1ON DATEAUTO DIAL SETUPPRESS AUTO DIAL ALARM SETUPPRESS
