27-127 VMC SetupThe Vapor Monitoring Controller (VMC) Setup function allows you to monitor a series of up to 18 dispensermounted, Gilbarco Vapor Monitor Controllers via an installed VMCI comm board.The VMCI board will poll eachVMC on the bus, and periodically upload the VMC information back to the TLS. The TLS supports the installationof only 1 VMCI comm board. Additional VMCI boards will cause Setup Data Warnings. A VMCI board must beinstalled in the TLS for the VMC Setup function to appear. NOTE: VMC setup will not be saved in E2. On coldboot, the VMC serial numbers entered during setup will have to be reentered following the setup procedure below.Selecting the VMC Setup FunctionTo enter VMC Setup, press FUNCTION until you see the message:Press STEP to continue. Press PRINT to printout current VMC setup(see example at right).Add a VMC Serial NumberIf necessary, press STEP until you see the message:Press ENTER.Enter the serial number of the displayed VMC or press TANK/SENSOR repeatedly until the desired VMCdisplays. Press CHANGE and enter the VMC’s serial number. Press ENTER to confirm your entry. Press STEP tocontinue.Edit a VMC Serial NumberIf necessary, press STEP until you see the message:Press ENTER. If necessary, press TANK/SENSOR repeatedly until the desired VMC displays.Press CHANGE and enter the revised serial number of the displayed VMC. Press ENTER to confirm your entry.Press STEP to continue.VMC SETUPPRESS TO CONTINUEVMC SETUP- - - - - - - - - - -VMC S/N1 0058302 0058133 002209consoles\vmcsetup.epsADD VMC SERIAL NUMBERPRESS ADD VMC SERIAL NUMBERx 1:EDIT VMC SERIAL NUMBERPRESS EDIT VMC SERIAL NUMBERx 1: 111111
