6 Communications Setup Port Settings6-4Press STEP to continue.SETTING THE MODEM TYPE (INTERNATIONAL INSTALLATIONS)This feature lets you select the modem used with a SiteLink Module.Press ENTER to accept the modem option or press CHANGE and then ENTER to choose US ROBOTICS (UK),VR TLS ANALOG MOD, or VR TLS GSM MODEM. Press STEP to continue.MODEM SETUP STRINGIf you have a modem installed, the system displays the message:This string will contain modem commands. The default for the string will be a blank string (no additionalcommands). Press CHANGE and enter up to 20 characters, e.g., AT&B1.Note: the’&’, ‘=’, and ‘%’ characters are available only when entering the Modem Setup String in all languagesexcept Japanese, Russian, Turkish, and Greek. See Table 2-1 on page 2-4 for instructions on entering thesecharacters.Press ENTER to select string and confirm selection, e.g.:Press STEP to continue.DIAL TONE INTERVALIf you have a modem installed, the system displays the message:This feature allows the user to program the console to check the phone lines every selected number of hours. Ifafter three sequential checks in which the line is not operative, a NO DIAL TONE is posted. The default interval is32 hours and can be set from 1 to 9999. Press CHANGE and enter the desired interval, e.g., 48. Press ENTER toselect your entry and the system displays the message:Press STEP to continue.DTR NORMAL STATEIf you have a S-Sat Module installed, the system displays the message:COMM BOARD: 1 (S-Link)MODEM: NETCOMM SMART M7FMODEM SETUP STRINGc 1:MODEM SETUP STRINGc 1: AT&B1COMM BOARD: 1 (Type)DIAL TONE INTERVAL: 32COMM BOARD: 1 (FXMOD)DIAL TONE INTERVAL: 48COMM BOARD: 1 (S-SAT)DTR NORMAL STATE: HIGH
