5-35 System Setup Setting the Date and Time FormatYou can set the system units to U.S. units (gallons, gal/hour, inches, F), metric units (litres, litres/hour, millimeters,C), or imperial gallons (imperial gallons, imp. gal/hour, inches, F). If the HRM feature was enabled (see “TLS-350Consoles” on page 4-1), the default units will be metric.NOTE: If you change the System Units after entering other quantitative setup values, the system converts values tothe new units. The Date format also changes according to your selection of System Units.To choose U.S. units, press STEP. (The system displays the SET DATE message.)To choose metric, press CHANGE in response to the SYSTEM UNITS message and press ENTER. To chooseimperial gallons, press CHANGE twice in response to the SYSTEM UNITS message and press ENTER. Thesystem confirms your choice with the message:Press STEP to continue.Setting the Date and Time FormatIf necessary, press STEP until you see the message:To accept the format shown, press STEP. (The system displays the SET TIME message).Available date/time formats are:• MON DD YYYY HH:MM:SS (APR 01 2002 10:02:30)• MM-DD-YY HH:MM:SS xM (04-01-02 10:02:30 AM); xM is AM or PM• MM-DD-YY HH:MM:SS (04-01-02 10:02:30)• DD-MM-YY HH:MM:SS (01-04-027 10:02:30)• YY-MM-DD HH:MM:SS (02-04-01 10:02:30)Press CHANGE until the desired format is shown, then press ENTER. Press STEP to continue.Current DateIf necessary, press STEP until you see the message:To accept the date shown, press STEP. (The system displays the SET TIME message).To change the date shown, press CHANGE, enter the correct date by first entering the month then the day thenthe year following the format shown on the display, then press ENTER. The system confirms your entry with themessage:Press STEP to continue.[Selected Units]PRESS TO CONTINUESYSTEM DATE/TIME FORMATMON DD, YYYY HH:MM:SS xMSET: MONTH DAY YEARDATE: XX/XX/XXXXDATE: XX/XX/XXXXPRESS TO CONTINUE
