5-135 System Setup Remote Printer Page EjectRemote Printer Page EjectIf necessary, press STEP until you see the message:NOTE: This system feature is for systems equipped with a Remote Printer Interface Module and Remote Printeronly.Enabling this feature forces the printer to start each new report on a new page. If you disable this feature, newreports will print continuously on the same page as the previous report.To have each new report begin on a new page, press CHANGE in response to the REMOTE PRINTER PAGEEJECT message. Then press ENTER. The system confirms your choice with the message:Print TC VolumesIf necessary, press STEP until you see the message:Use this display to enable or disable the display and printout of TC volumes. Press STEP to accept or CHANGEand ENTER to disable this feature. The system confirms your choice with the message:Temperature Compensation ValueThe system allows you to enter the temperature compensation (TC) reference temperature for all volumecalculations. This temperature is determined by your location. In the U.S., the reference temperature used tocalculate TC volume is normally 60°F. In other countries, this value may differ. Canada, for example, uses 15°C.Press STEP to display the message:TLS-350R only—If BIR is being used and the meters reporting the sales are temperature compensated, the valueyou enter must match the meters’ reference temperature value. Also, in BIR setup, Temp Compensation must beset to TC VOLUME (see “Temp Compensation” on page 17-4).LEAK CALCULATIONS NOTE: All leak calculations are based on the reference temperature you enter.DENSITY CALCULATIONS NOTE: If you are using the Density/Mass feature, the reference temperature enteredhere is used in Density reporting.To accept the default value of 60°F (15.6°C), press STEP.REMOTE PRINTERPAGE EJECTPAGE EJECT ENABLEDPRESS TO CONTINUEPRINT TC VOLUMESENABLEDDISABLEDPRESS TO CONTINUETEMP COMPENSATIONVALUE (DEG F): +060.0
