17-117 Reconciliation SetupTo select Reconciliation Setup, press FUNCTION until you see the message:Press STEP to continue.International installations - for consoles without BIR, the HRM Features DIP switch (see “TLS-350 Consoles” onpage 4-1) must be enabled to enter Reconciliation Setup.Dispenser Module Data StringIf necessary, press STEP until you see the message:Device codes for the two types of DIM modules are a “M” for Mechanical Dispenser Interface Modules (MDIM),and an “E” for Electronic Dispenser Interface Modules (EDIM). All EDIM modules install in the Comm Bay of theconsole and include; Current Loop, Block, RS-232, IFSF, and RS-485 dispenser interface modules. All MDIMmodules install in the Power Bay of the console and include; Low Voltage Mechanical, and High VoltageMechanical Dispenser Interface Modules.When a BDIM, EDIM, or CDIM is installed, the system will recognize its presence and position in the Comm Bayof the console. When a MDIM is installed, the system will recognize its presence and position in the Power Bay.To enter a dispenser module data string, press CHANGE, enter a valid DIM description selected from theappropriate DIM Installation Manual. The system accepts up to twelve alphanumeric characters; however, it readsonly the first eight. If no data are entered, the DIM defaults are used.After entering your description, press ENTER. The system confirms your entry with the following message:If more than one DIM is installed, the system will automatically advance to the next module when setup for one iscomplete. You can also press TANK/SENSOR to select a specific module. When all DIM modules have been setup, press STEP to advance to the next feature. (The system displays the AUTOMATIC DAILY CLOSINGmessage.)Automatic Daily ClosingIf necessary, press STEP until you see the message:Enter the time you wish to designate as the daily closing time. At the programmed time, the system stores thecurrent day’s data, and prints a report if “Daily BIR Reports” was set to enabled in System Setup (page 5-5). Thedefault time is set to 2:00 a.m. This feature cannot be disabled.RECONCILIATION SETUPPRESS TO CONTINUEDISP. MODULE DATA STRINGEDIM #X: XXXXXXXXXDIM#X: [Description]PRESS TO CONTINUEAUTOMATIC DAILY CLOSINGTIME: 2:00 AM
