24-524 Output Relay Setup Assignment MethodREMAINING ALARM GROUPSContinue to step through all of the available alarm groups, selecting the various alarms from the groups that youwant to assign to the selected relay (R1, R2, etc.). The procedure for bypassing or selecting alarms from eachgroup and then assigning them to a device in that group is the same as discussed for In-Tank alarms above.The remaining alarm groups/alarms are shown below. Only installed components will display, so some of the alarmgroups may not appear.LIQUID SENSOR ALARMSIf necessary, press STEP until you see the message:Select the Liquid Sensor Alarms (ref. Alarm List in Section 6, Table 6-2).VAPOR SENSOR ALARMSIf necessary, press STEP until you see the message:Select the Vapor Sensor Alarms (ref. Alarm List in Section 6, Table 6-2).EXTERNAL INPUTS ALARMSIf necessary, press STEP until you see the message:Select the External Inputs Alarm (ref. Alarm List in Section 6, Table 6-2).LINE LEAK ALARMS (VLLD)If necessary, press STEP until you see the message:Select Volumetric Line Leak Alarms (ref. Alarm List in Section 6, Table 6-2).GROUNDWATER SENSOR ALARMSIf necessary, press STEP until you see the message:Select Groundwater Sensor Alarms (ref. Alarm List in Section 6, Table 6-2).R1: (Name)LIQUID SENSOR ALMS: NOR1: (Name)VAPOR SENSOR ALMS: NOR1: (Name)EXTERNAL INPUTS: NOR1: (Name)LINE LEAK ALARMS: NOR1: (Name)GROUNDWATER ALMS: NO
