26-126 Smart Sensor SetupYour console may have Smart Sensors installed. Once a Smart Sensor is configured, the system reads thesensor’s feature set and programming options. After configuring each Smart Sensor, you should printout the SmartSensor Setup before attempting to program the sensor.NOTE: If Smart Sensor modules are not installed, this function is not available.Selecting the Smart Sensor Setup FunctionTo select Smart Sensor Setup, press FUNCTION until you see the message:Press STEP to continue.Sensor ConfigurationIf necessary, press STEP until you see the message:When Smart Sensor Interface Modules (8 inputs) or Smart Sensor / Press Modules (7 inputs) are installed, thesystem recognizes the presence and module slot locations of each one. The system also designates the modulenumber (n) based on the slot location. In this display you tell the system which positions on the module have beenconnected to sensors.As you tell the system which sensor positions on a module are connected, the system establishes a number foreach sensor. For example, if there are sensors connected to positions 2 and 4 of module 1, the sensor in position2 becomes s2 and the sensor in position 4 becomes s4.To specify whether position 1 is connected, press CHANGE until the correct choice appears (1 if the position isconnected, X if it is not). Press the Right Arrow key to move to position 2 and press CHANGE again until thecorrect choice appears (2). Repeat these steps until you have correctly specified all sensors connected to thisSmart Sensor module. Press ENTER to confirm your entry:Press STEP. If more than one module is installed, the system automatically advances to the SS CONFIG messagefor the next module. Up to 40 smart sensors can be monitored by the console.NOTE: At least one Smart Sensor / Press module is required with Vac Sensors. You can use either additionalSmart Sensor / Press Modules or 8-input Smart Sensor Interface Modules if more than 7 Vac Sensors areinstalled.Repeat the steps described above for each module until you have entered the configuration information (sensorpositions) for all modules and the system displays the ENTER SMARTSENSOR LABEL message.When you have finished configuring all Smart Sensors, press the PRINT key to printout a copy of each sensorsfeature set and programming options (see example printout below).SMART SENSOR SETUPPRESS TO CONTINUESS CONFIG - MODULE nSLOT #: X X X X X X X XSLOT #: X X X X X X X XPRESS TO CONTINUE
