PRINTING WITH THE 4213A skewed image is usually the result of:• The sheet not being flush against the left feed guide when itis inserted into the bypass slot• The sheet not being held in place at the bypass slot entrancewhen it began to move through the bypass slot.Note: The maximum size of paper which can be manually fed is216 by 279 mm (8.5 by 14 inches). The minimum size is 99 by191 mm (3.88 by 7.5 inches). Do not try to 2-sided anythingother than A4 or legal size paper while using manual feed or apaper jam could occur.Printing on envelopesAddresses are formatted to print on standard sized envelopes. Inthe LJ2D emulation, you can select one of the standardenvelopes listed in table 4-5 using the PAPER SIZE menu item. Inthe other emulations, you must format your pages for theenvelopes you are using before you submit your print job.Envelopes are printed in the landscape orientation.The address is placed on the envelope, according to the size ofthe envelope being fed. Envelopes are printed using the bypasstray. Refer to “Selecting the bypass tray at the printer,” sectionshown earlier in this chapter for information on how to select thebypass tray at the Main Menu.You can set the envelope size in one of three ways:• If your application software allows you to select the envelopesize, the selected paper size command is automatically sentto the printer and the image is placed in the correct locationon the envelope.• You can access the LJ2D emulation configuration in the MainMenu and select one of the standard sizes listed in table 4-5from the LJ2D paper size options. Refer to the next section,“Setting the envelope size at the LJ2D sub-menu.”• You can send a printer command, or an escape sequence, tolet the printer know the envelope size you are using. Referto the LJ2D or XES section in the Rank Xerox 4213 LaserPrinter Programmer Reference for information on pageformatting commands.4-28 XEROX 4213 LASER PRINTER USER GUIDE
