XEROX COAX/TWINAX OPTIOND 11. When the password entry is completed, press the Selectbutton. The display should reads:IBM COMMSCOAX*C 12. Press the Last Page. The display reads:IBM COMMSTWINAXD 13. Press the Select button to select the Twinax communicationsoption.You may immediately use the IBM Twinax interface by followingthe final step below.H 14. Press the Online button to take the printer online. This stepis necessary to initialise the Twinax option. The green onlineindicator light is lit and the 4213 is ready and the IBM Twinaxinterface is in place.Note: Initialising the Twinax option by pressing the onlinebutton to put the 4213 back online will restart the hostcommunication and reload the configuration option with Twinaxconfiguration defaults.H 15. Press the Online button to take the printer off line to re-configure the Twinax option, if required. The green onlineindicator light is not lit.Notes • The Twinax configuration sheet will not print unless theCoax/Twinax host interface is selected and activated.• If you wish to change any of the IBM Twinax interfaceconfiguration options, proceed to “Changing the IBM TwinaxConfiguration” section. If you wish the IBM Twinax interfaceto be in place each time the 4213 is switched on, proceeddirectly to “Saving the IBM Twinax configuration” section.Setting different options under the IBM Main Menu for TwinaxTo change the IBM Twinax interface configuration, follow steps 1to 7 in the previous section to access the IBM Main Menuheading.B • Use the Test button to move to the next lower menulevel.XEROX 4213 LASER PRINTER USER GUIDE A3-67
