Refer to Table 220 for the description of the input-output relationship in terms of thevalue and the quality attributes.Table 220:Description of the input-output relationshipVALID OPEN CLOSE POSITIONValue Description0 - - 0 Intermediate1 0 0 0 Intermediate1 1 0 1 Open1 0 1 2 Closed1 1 1 3 Bad State14.4 Single point generic control 8 signals SPC8GAPCSEMOD176448-1 v314.4.1 IdentificationSEMOD176456-2 v3Function description IEC 61850identificationIEC 60617identificationANSI/IEEE C37.2device numberSingle point generic control 8 signals SPC8GAPC - -14.4.2 Functionality SEMOD176462-4 v10The Single point generic control 8 signals (SPC8GAPC) function block is a collectionof 8 single point commands that can be used for direct commands for example reset ofLEDs or putting IED in "ChangeLock" state from remote. In this way, simplecommands can be sent directly to the IED outputs, without confirmation. Confirmation(status) of the result of the commands is supposed to be achieved by other means, suchas binary inputs and SPGAPC function blocks. The commands can be pulsed or steadywith a settable pulse time.1MRK 511 408-UUS A Section 14ControlPhasor measurement unit RES670 2.2 ANSI 391Technical manual
