Danfoss VLT AQUA Drive FC 202 Programming Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

2.2.1 The LCP DisplayThe LCP display has backlight and a total of 6 alpha-numeric lines. The display lines show the direction ofrotation (arrow), the selected set-up, and the programmingset-up. The display is divided into 3 sections.Top sectionShows up to 2 measurements in normal operating status.Middle sectionThe top line shows up to 5 measurements with relatedunits, regardless of status (except if there is an alarm/warning).Bottom sectionAlways shows the state of the frequency converter inStatus mode.Top sectionMiddle sectionBottom sectionStatus43 RPM1.4 HzAuto Remote Running! Pwr.card temp (W29)2.9%5.44 A 25.3kW1(1)130BP074.10!Illustration 2.2 Bottom SectionThe active set-up (selected as the active set-up inparameter 0-10 Active Set-up) is shown. When programminganother set-up than the active set-up, the number of theprogrammed set-up appears to the right.Display contrast adjustmentPress [Status] and [▲] for darker display.Press [Status] and [▼] for brighter display.Most parameter set-ups can be changed immediately viathe LCP, unless a password has been created viaparameter 0-60 Main Menu Password or viaparameter 0-65 Quick Menu Password.Indicator lightsIf certain threshold values are exceeded, the alarm and/orwarning indicator lights up. A status and an alarm textappear on the LCP.The ON indicator light is activated when the frequencyconverter receives mains voltage, or via a DC bus terminal,or a 24 V external supply. At the same time, the backlightis on.• Green LED/On: Control section is working.• Yellow LED/Warn.: Indicates a warning.• Flashing red LED/Alarm: Indicates an alarm.OnWarn.Alarm130BP044.10Illustration 2.3 Indicator LightsLCP keysThe control keys are divided into functions. The keys belowthe display and indicator lights are used for parameter set-up, including the option of display indication duringnormal operation.130BP045.10Status QuickMenuMainMenuAlarmLogIllustration 2.4 LCP Keys[Status]Indicates the status of the frequency converter and/or themotor. Select between 3 different readouts by pressing[Status]: 5-line readouts, 4-line readouts, or smart logiccontrol.Press [Status] to select the mode of display or to return todisplay mode from either the Quick Menu mode, the MainMenu mode, or Alarm mode. Also use [Status] to togglesingle or double readout mode.[Quick Menu]Provides quick access to the most common functions ofthe frequency converter.The [Quick Menu] consists of:• Q1: My personal menu.• Q2: Quick set-up.• Q3: Function set-ups.• Q4: SmartStart.• Q5: Changes made.• Q6: Loggings.• Q7: Water and pumps.How to Program VLT® AQUA Drive FC 20214 Danfoss A/S © 05/2018 All rights reserved. MG20OB0222