Danfoss VLT AQUA Drive FC 202 Programming Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

Status screen IThis readout state is standard after start-up or initialization.Press [Info] to obtain information about the measurementlinks to the shown operating variables (1.1, 1.2, 1.3, 2 and3).See the operating variables shown in Illustration 2.11.1.123 1.31.2130BP041.10799 RPMAuto Remote Ramping1 (1)36.4 kw7.83 A0.00053.2 %StatusIllustration 2.11 Status Screen IStatus screen IISee the operating variables (1.1, 1.2, 1.3, and 2) shown inIllustration 2.12.In the example, speed, motor current, motor power, andfrequency are selected as variables in the first 2 lines.1.11.221.3 130BP062.10207RPMAuto Remote Running1 (1)24.4 kW5.25A6.9HzStatusIllustration 2.12 Status Screen IIStatus screen IIIThis state shows the event and action of the smart logiccontrol. For more information, see parameter group 13-**Smart Logic.130BP063.10778 RPMAuto Remote Running1 (1)4.0 kW0.86 AState: 0 off 0 (off )When: -Do: -StatusIllustration 2.13 Status Screen III2.2.5 Parameter Set-upThe frequency converter can be used for practically allassignments and offers 2 programming mode options:• Main menu mode.• Quick menu mode.Main menu provides access to all parameters. Quick menutakes the user through a few parameters, making itpossible to start operating the frequency converter.Change a parameter in either main menu mode or quickmenu mode.2.2.6 Quick Menu Key FunctionsPress [Quick Menu] to enter a list of different areascontained in the Quick Menu.Select Q1 My Personal Menu to show the selected personalparameters. These parameters are selected inparameter 0-25 My Personal Menu. Up to 50 differentparameters can be added in this menu.130BC916.10Q1 My Personal MenuQ2 Quick SetupQ4 Smart SetupQ5 Changes Made0RPM 0.00A 1(1)Quick MenusIllustration 2.14 Quick MenusSelect Q2 Quick Setup to go through a selection ofparameters to get the motor running almost optimally. Thedefault settings for the other parameters consider therequired control functions and the configuration of signalinputs/outputs (control terminals).The parameter selection is effected with the navigationkeys. The parameters in Table 2.1 are accessible.How to Program VLT® AQUA Drive FC 20218 Danfoss A/S © 05/2018 All rights reserved. MG20OB0222