24-02 Emergency Mode UnitOption: Function:[11] RPM[12] Pulse/s[20] l/s[21] l/min[22] l/h[23] m³/s[24] m³/min[25] m³/h[30] kg/s[31] kg/min[32] kg/h[33] t/min[34] t/h[40] m/s[41] m/min[45] m[60] °C[70] mbar[71] bar[72] Pa[73] kPa[74] m WG[75] mm Hg[80] kW[120] GPM[121] gal/s[122] gal/min[123] gal/h[124] CFM[125] ft³/s[126] ft³/min[127] ft³/h[130] lb/s[131] lb/min[132] lb/h[140] ft/s[141] ft/min[145] ft[160] °F[170] psi[171] lb/in²[172] in WG[173] ft WG[174] in Hg[180] HP24-03 Emergency Mode Min ReferenceRange: Function:Sizerelated*[ -999999.999- par. 24-04FireModeUnit]Minimum value for the reference/setpoint (limiting the sum of value inparameter 24-05 Emergency ModePreset Reference and value of signal oninput selected inparameter 24-06 Emergency ModeReference Source).If running in open loop whenemergency mode is active, the unit isselected by the setting ofparameter 0-02 Motor Speed Unit. Forclosed loop, select the unit inparameter 24-02 Emergency Mode Unit.24-04 Emergency Mode Max ReferenceRange: Function:Sizerelated*[ par. 24-03- 999999.999FireMo-deUnit]Maximum value for the reference/setpoint (limiting the sum of value inparameter 24-05 Emergency Mode PresetReference and value of signal on inputselected in parameter 24-06 EmergencyMode Reference Source).If running in open loop whenemergency mode is active, the unit isselected by the setting ofparameter 0-02 Motor Speed Unit. Forclosed loop, select the unit inparameter 24-02 Emergency Mode Unit.24-05 Emergency Mode Preset ReferenceRange: Function:0 %* [-100 -100 %]Enter the required preset reference/setpoint as apercentage of the value inparameter 24-04 Emergency Mode Max Reference.The set value is added to the value representedby the signal on the analog input selected inparameter 24-06 Emergency Mode ReferenceSource.Parameter Description VLT® AQUA Drive FC 202204 Danfoss A/S © 05/2018 All rights reserved. MG20OB0233