Appendix C—Optional Communication Cards210 Power Xpert C445 Global Motor Management Relay MN042003EN—October 2016 www.eaton.comInstance AttributesSr. No. Attribute ID Access Data Type Attribute Name Attribute Description1 1 (0x1) Get/Set USINT Remote Modbus Address Remote Modbus Address2 2 (0x2) Get/Set USINT Remote Modbus Baud Rate Remote Modbus Baud Rate3 3 (0x3) Get/Set USINT Remote Modbus Parity and Stop Bits Remote Modbus Parity and Stop Bits4 4 (0x4) Get/Set USINT Remote Modbus TX Mode Remote Modbus TX Mode5 5 (0x5) Get/Set UINT Remote Modbus Communication Timeout Remote Modbus Communication Timeout6 6 (0x6) Get/Set UINT Base Control Module USB ModbusCommTimeoutBase Control Module USB Modbus CommTimeout7 7 (0x7) Get/Set UINT User Interface USB ModbusCommTimeoutUser Interface USB Modbus CommTimeout8 8 (0x8) Get/Set UINT Modbus Scan Data Modbus Scan Data9 9 (0x9) Get/Set UINT Modbus Scan List Modbus Scan ListTable 105. Motor Monitoring Object—Class 0xA1 (161)Class ServicesServiceCode Service Name0x0E Get Attribute SingleInstance ServicesServiceCode Service Name0x0E Get Attribute Single0x10 Set Attribute SingleClass AttributesSr. No. Attribute ID Access Rule Data Type Name Attribute Description1 1 (0x1) Get UINT Revision Revision of this object2 2 (0x2) Get UINT Max Instance Maximum instance number of an object currently createdin this class level of the device.3 3 (0x3) Get UINT Number of Instances Number of object instances currently created at this classlevel of the device.Instance AttributesSr. No. Attribute ID Access Data Type Attribute Name Attribute Description1 1 (0x1) Get USINT Motor State (enum) Motor State (enum)2 2 (0x2) Get UINT Speed (RPM) Speed (RPM)3 3 (0x3) Get INT Torque Torque4 4 (0x4) Get UINT Efficiency in percent Efficiency in percent5 5 (0x5) Get USINT PTC Status PTC Status6 6 (0x6) Get UDINT Number of Motor Starts Number of Motor Starts7 7 (0x7) Get UINT Number of Contactor Operations DuringLast HourNumber of Contactor Operations During Last Hour8 8 (0x8) Get/Set UDINT Number of Motor Starts User Number of Motor Starts User9 9 (0x9) Get UDINT Number of Operating Seconds Number of Operating Seconds10 10 (0xA) Get/Set UDINT Number of Operating Seconds (user) Number of Operating Seconds (user)11 11 (0xB) Get UINT Last Measured Starting Time. Time to getup to speed.Last Measured Starting Time. Time to get up to speed.12 12 (0xC) Get UDINT Motor Run Time Latest Run - How long themotor was running last time.Motor Run Time Latest Run - How long the motor wasrunning last time.13 13 (0xD) Get UDINT Motor Run Time Total Motor Run Time TotalTable 104. Modbus Object—Class 0xA0 (160), continued
