Chapter 5—System Configuration and Operation82 Power Xpert C445 Global Motor Management Relay MN042003EN—October 2016 www.eaton.comFigure 90. C445UC-N0: NEMA Control and StatusFigure 91. C445UC-N1: NEMA Status OnlyFigure 92. C445UC-N4: NEMA Control and StatusOverlay Display:● OFF LED solid On – Motor is off in “ready” state – nocurrent detected, no faults present● OFF LED blinking On – Motor is off, C445 control is faultedand/or a control inhibit is present● RUN LED solid On – Active RUN1 command and motor isup to speed – complete start detected● RUN LED blinking On – Active RUN1 command but motoris NOT up to speed● AUTO LED Off – C445 control is local source● AUTO LED On – C445 control is remote sourceOverlay Buttons:● OFF button – Button press will put the control in “Local”and will send a STOP command to the C445 overload todrop out the starter.● RUN button – Button press will put the control in “Local”and will send a RUN1 command to the C445 overload tostart the starter.● AUTO button – Selects the remote source as the activeC445 control● RESET button – Resets fault if condition has cleared● HAND button – Button press will put the control in “Local”and will send a RUN1 command to the C445 overload tostart the starter.
