Chapter 3—Installation and WiringPower Xpert C445 Global Motor Management Relay MN042003EN—October 2016 www.eaton.com 19C445 MountingTo aid with the panel layout of the Power Xpert C445modules, refer to the dimension drawings.The C445MB… Base Control Module and the C445M…Measurement Modules are designed to be mounted utilizinga standard 35 mm DIN rail or utilizing a panel mount method.When mounting the modules on 35 mm DIN rail, ensure thatthe rail is properly secured to support all devices installed onthe rail.All C445 devices may be panel mounted The C445B… basemodule and C445MA… Measurement Module utilizeoptional mounting feet that are snapped into place. Aminimum of two (2) mounting feet are required. Tabs areinstalled at locations so one tab is on the top and one onthe bottom of the device when mounted vertically.C445MB… and C445MC… Measurement Modules havemounting tabs molded into the housing assembly.Installation of panel mount screws on all mount tabs arerequired.The C445B… base module may be installed directly on top ofthe C445MA… Measurement Module by aligning the matingslots of the two devices and snapping them together. If thetwo devices are to be panel mounted, all four(4) panel mounttabs are required.Table 8. Mounting HardwareThe C445B…/C445MA… combined assembly may be mounted on a 35 mm DIN-Rail.C445 Surface Mounting on DIN railPlace the C445 device onto the mounting rail from above [1],push down [2], and allow the device to snap into position.To remove any C445 device from a rail, gently press down onthe unit and then pull the lower housing edge away from therail. Lift the C445 device upward and off the mounting rail.Figure 22. DIN-Rail Mounting InstructionsFigure 23. DIN Rail DimensionsMounting Fasteners mm, Grade 4.8 SAE Grade 5Device Quantity Size Grip Torque Size Grip TorqueC445B… 2 M5 0.8 mm 2.0 – 2.7 Nm #10 0.032 in 30 – 42 lb/inC445B… & C445MA… 4 M5 0.8 mm 2.0 – 2.7 Nm #10 0.032 in 30 – 42 lb/inC445MB… 2 M5 8.0 mm 2.0 – 2.7 Nm #10 0.312 in 30 – 42 lb/inC445MC… 4 M5 8.0 mm 2.0 – 2.7 Nm #10 0.312 in 30 – 42 lb/in112357.5115
