Chapter 6 HPSS ConfigurationHPSS Installation Guide September 2002 333Release 4.5, Revision 26.8.4 Log Client Specific ConfigurationThe Log Client specific configuration entry can be created using the Logging Client Configurationwindow. After the configuration entry is created, it can be viewed, updated, or deleted through thesame window.From the HPSS Health and Status window (shown in Figure 6-1 on page 252), click on the Adminmenu, select the Configure HPSS option and click on the Servers option. The HPSS Serverswindow will be displayed as shown in Figure 6-5 on page 264.To add a new specific configuration, select the Log Client entry and click on the Type-specific...button from the Configuration button group on the HPSS Servers window. The Logging ClientConfiguration window will be displayed as shown in Figure 6-23 on page 334 with default values.If the default data is not desired, change the fields with the desired values. Click on the Add buttonto create the configuration entry.To update an existing configuration, select the Log Client entry on the HPSS Servers window andclick on the Type-specific... button from the Configuration button group. The Logging ClientConfiguration window will be displayed with the configured data. After modifying theconfiguration, click on the Update button to write the changes to the appropriate SFS file.To delete an existing configuration, select the Log Client entry on the HPSS Servers window andclick on the Type-specific... button from the Configuration button group. The Logging ClientConfiguration window will be displayed with the configured data. Click on the Delete button todelete the specific configuration entry.DefaultWait TimeThe default number of seconds theclient will wait before retrying arequest if not determined by theSite Interface.The value must begreater than zero and isonly used if the SiteInterface returns a waittime of zero for thecreate, open, or stagerequest being retried.10Note: The Client API uses the environment variable HPSS_GKTOTAL_DELAY toplace a maximum limit on the number of seconds a call will delay because ofHPSS_ERETRY status codes returned from the Gatekeeper. See Section 7.1: ClientAPI Configuration on page 413 for more information.Site PolicyPath NameThe UNIX pathname where thesite policy will be stored. Thecontents of this file will be definedby the site and should becoordinated with the site writteninterface library.Empty, or any legalUNIX pathname./var/hpss/gk/gksitepolicyTable 6-18 Gatekeeper Configuration FieldsDisplayFieldNameDescription Acceptable Values Default Value
