Chapter 6 HPSS Configuration406 September 2002 HPSS Installation GuideRelease 4.5, Revision 2Device /Drive Type The type of device overwhich data will move.Any valid type from the pop-up list. Default Tapeor DefaultDisk, basedon Tape/Disktogglebuttons.Mover The name of the MVR thatcontrols the device.Any configured MVR name fromthe pop-up list.FirstconfiguredMVR namefound in theSFS file.Advice: There is a maximum of 64 devices that can be configured for a Mover.PVR The name of the PVR thathandles the removablemedia operations for thedrive.Any configured PVR name fromthe pop-up list.FirstconfiguredPVR namefound in theSFS file.Advice: This field is meaningful for tape devices only.Mounted Volume The 8-character name ofthe volume mounted onthe disk drive, if any.Valid 8-character name assigned tothe disk volume.NoneAdvice: This value is meaningful for disk devices only.Bytes on Device The size of device in bytes. Any positive 64-bit integer value upto the system-imposed maximumdevice size.NoneAdvice: This value is used for disk devices only. If it is modified after the mounteddisk volume has been imported into HPSS, the volume must be re-imported intoHPSS.Note that the PV Size from Section 6.7 for the storage class must be less than orequal to the value of Bytes on Device.If the Starting Offset is non-zero, then the Bytes on Device value cannot be greaterthan the actual size of the underlying device less the Starting Offset value.Table 6-33 Device/Drive Configuration Variables (Continued)Display Field Name Description Acceptable Values DefaultValue
