1194. Set [Delay Distance].Input the distance from sensor for trigger to the startingposition of the marking using laser marker.Here, set the distance to 60 mm.5. Set [Line Speed].Here, set the speed to 0.060 m/min.SensorDelay distanceWork directionSensorDelay distanceWork directionNotice• Fine-adjust the delay distance by executing the test marking actually.Reference• When the line speed fluctuates, use [Encoder signal]. In such case, enter the number of encoder pulses. When theencoder is not used, marking on flying objects is executed by applying the calculation result based on the line speedalready input.For the encoder signal, refer to “Trigger Selection” (P.221).ME-LP400V-OP-6
