187Description9 Size (only for DXF file format) :Specifies size specification method of DXF file data.• Height・Width : Sets height and width respectively.• Width (Keep Height Ratio) : Sets width with height ratio fixed.• Height (Keep Width Ratio) : Sets height with width ratio fixed.• Original : Sets DXF file size as original size.10 Height, Width (only for DXF file format) :Sets height / width of DXF file data.Setting Range0.100 to 90.000 mm (LP-V10)0.100 to 110.000 mm (LP-430 / LP-420 / LP-410)0.100 to 160.000 mm (LP-435 / LP-425 / LP-V15)0.100 to 55.000 mm (LP-431 / LP-421 / LP-411 / LP-W052)11 Font (only for DXF file format):Specifies font type to be used for the text character in DXF file data.The font can be selected for each logo file.12 Marking Pitch (only for DXF file format):Sets marking pitch of the solid hatching drawing in DXF file data.Setting Range 0.010 to 2.000 mm13 Marking Direction (only for DXF file format) :Sets marking direction of the solid hatching drawing in DXF file data. Both vertical and horizontal directions aresettable.14 Laser Power Correction :Scan Speed Correction :Laser Pulse Cycle Correction (Only LP-V series) :Correction of each logo No. for the laser power / scan speed / laser pulse cycle set at laser setting.Setting Range of Laser Power Correction 0 to 200%Setting Range of Scan Speed Correction 5 to 500%Setting Range of Laser Pulse Cycle Correction 50 to 200%Reference• If the value of “Laser power correction” × “laser power” is equal to or larger than 100, the setting will be “100”.• Marking is not available when the laser power correction value is “0”.• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.15 Area No. :Displayed when marking on-the-fly is set in “Trigger setting”.It indicates the order of the marking field for the concatenated marking to flying object.Setting Range 0 to 15ME-LP400V-OP-6
