215Description4 Duty Cycle (Only LP-W series) :This is the ratio of laser ON time in the setting pulse cycle time.Setting Range 50 to 100%Initial Value 100%5 Line Width :Specifies the interval between lines at the intersection point in a character when they are crossed.If there is a space at the intersection point of the character or it is marked too deeply, adjust this value.Setting Range 0.010 to 2.000 mm with the increment of 0.001 mm.Line WidthToo large line width Proper Too small line widthLine Width Line WidthReference• This correction is invalid for some user-registration characters.• This correction is not effective for the logo data.• When requiring the thicken the actual marking width, set the line width for bold character at character condition. Referto “4-10-2 Character Conditions” (P.180).• The time for marking may be long if the setting value of the line width is smaller.• The initial value of the line width is set depending on the model as follows;LP-430/LP-420/LP-410 : 0.18mm LP-431/LP-421/LP-411 : 0.11mm LP-435/LP-425 : 0.26mmLP-V10 : 0.06mm LP-V15 : 0.10mm LP-W052 : 0.04mm6 Marking Pitch :This item sets the density of the marking of the bold character and bar code.Setting Range 0.010 to 2.000 mmMarking PitchBold line widthorModule width of barcodeBold line widthorModule width of barcodeMarking PitchReference• The width of bold line changes when the setting value in the “Line Width” is different from that marked with laser.• This correction is not effective for the logo data.• It is recommended that the marking pitch is specified so that it is an integral multiple of half of the marking line width.ME-LP400V-OP-6
