240Description10 X/Y Position :Inputs the coordinate value of X or Y axis. Press the numerical value to display a ten-key pad.11 X/Y Position Fine Adjustment :Fine-adjusts the target marking contents to up/down or right/left direction. (in 0.001mm pitch)*1 : Displayed only with the setting for marking of flying object.4-14-2 Work Image DisplayIn case there are data which you will see on the image display, but not be marked, such as the outline data of the markingobject or characters, setting 0% to “Laser Power Correction”. Then, the data are showed with gray figure on the imagedisplay.The marking data which are set to 0% for “Laser Power Correction” are not marked. They do not affected the marking timeetc. as well.Reference• When “Laser Power Cor.” is set to 0%, these character, logo, barcode or processing data are not traced with the guidelaser “Marking Character” mode.ME-LP400V-OP-6
