306ERRORCODE Error details MeasuresE640 Invalid function for combining with flying object.• With the marking to flying object, do not use thefollowing functions.• Step & repeat• Reset at date update function• Arbitrary point radiation• Overwrite function• With the equidistant marking to flying object, donot use the following functions.• Rank• External offset• Serial data marking• Release flying object marking function with triggersetting.E650 Invalid setting of processing element. Set the distance between start and end points of thearc smaller than double of radius.E651 Too short line segment of processing element. Set the larger value to the length of the line thanwidth of the line.E660 Cannot convert dxf file.• Save the DXF file with DXF-R12J, R13J or R14format.• Delete the entities which are not supported bylaser marker in the DXF file.• Read the DXF file again to the laser marker.E690 Cannot finish measurement during specified time.• Reduce marking contents and measure markingtime.• Speed up scan speed.E700 Unable to lase as laser pumping is turned OFF. Turn ON the laser pumping and after the laserpumping has completed, start marking.E701*1Started laser power check in laser pumping OFFstate.Turn ON the laser pumping and after the laserpumping has completed, start power check.E800---------------------------(no message : Invalid input of marking trigger whileReady is OFF.)• Change marking timing so that trigger input isperformed after marking ready output is turned on.• Check wiring and control procedure for I/Oterminal, wiring to communication port, and theprocedure of the communication command.E811 Occurred laser stop from external terminal.• Check the wiring of the laser stop input terminaland contact of the switch.• Confirm operation logic of connection device.E900Existed invalid function character for simultaneoususe.The following combination of the functions are notavailable in one file.• Serial data marking function and rank function• Serial data marking function and external offsetfunctionDelete any one of these functions from the file.E901 Existed invalid character for converting into 2D code. Set the character that can be converted into 2D code.E902 Cannot create 2D code. Use the condition where 2D code can be created.*1 : Error that may occur for LP-V / LP-W series only.ME-LP400V-OP-6
