943-3-2 Mark Expiry Date/TimeSample06 13Expiry DateMonth DateTime limit (EXPIRY) : 30 daysDisplayed number of digits (Figure) : 2Display format : Month/DateDisplay leading zeros (Zero Indi.) : EnableThe expiry date (30 days later) is marked.2. Input the function character of the expiry date.1. Set the expiry date.Refer to “3. Set the marking layout” (P.85) and “4. Set the laser condition” (P.86) in “3-2-3 Set the markingdata” (P.83).3. Set the conditions of the function character for the expiry date and laser.Notice• The following items, Date, Lot, and Expiry date are marked based on the internal clock of the laser marker.The internal clock might be deviated caused by the error of the internal parts or degree of the battery drain. Therefore,be sure to check the time of the internal clock before the operation without fail.Reference• For details on the expiry date function, refer to “4-9-1 Expiry Date” (P.162).• By using “TIME HOLD IN” signal of the I/O connector pin No. 23, the functional characters such as date/time and lotdo not update and the laser marker marks the time and date at the point when the input was turned ON. For the TIMEHOLD IN function, refer to the “External control manual”.ME-LP400V-OP-6
