176Description6 X/Y Offset :Shifts the object to X/Y direction. This coordinate is applied to the origin of the base object.Setting Range-45.000 to +45.000 mm (LP-V10)-55.000 to +55.000 mm (LP-430 / LP-420 / LP-410)-80.000 to +80.000 mm (LP-435 / LP-425 / LP-V15)-27.500 to +27.500 mm (LP-431 / LP-421 / LP-411 / LP-W052)7 Count up / down at each step :Check this box to validate the counter updating at each marking of Step & Repeat.Reference• Counter marking is impossible unless the functional character for counter has been input in the character string formarking.• In case the counter is included in the marking character and the “Count up/down at each step” is not selected, the allcounter values are the same in one Step & Repeat marking as shown in the figure below.1111111112222222223333333334444444448 Count “Mark OFF” :When the Step & Repeat counter is used and set the mark off in the specified pattern, select here whether thecounter value of the marking off part is counted or skipped.Refer to “Step & Repeat Fine-Adjustment” (P.178).Yes : Skips counter value on the column/row which “Mark OFF”.(ex) Step-Repeat with 3 rows × 3 columnsMarking OFF: marking on the 2nd row of 2nd lineDirection: Hori.Starting Position: Upper L14728369No : Not skip counter value on the column/row which “Mark OFF”.(ex) Step-Repeat with 3 rows × 3 columnsMarking OFF: marking on the 2nd row of 2nd lineDirection: Hori.Starting Position: Upper L14627358ME-LP400V-OP-6
