221⿎ Trigger SelectionSets the timing of marking start.• Trigger Marking : Starts the marking per marking trigger.• Equidistant Marking : Repeats marking with the interval specified while the marking trigger is turned to ON.(1) Trigger MarkingStarts marking to flying object per marking trigger. Setting parameters vary depending on whether the encoder is used ornot.When the encoder is not used(Encoder signal: invalid)When the encoder is used(Encoder signal: valid)123 4531Description1 Delay DistanceInputs the moving distance of line from trigger input to thestart of marking.Setting Range 0 to 500.00 mmReference• Set a delay distance shorter than the distance between theworkpieces.• When the next trigger signal is inputted during delay, warning(E800) occurs. (Only if “Detect TRIG. Warning during Marking”in Environment Setting is valid.)2 Line SpeedInputs the line speed. Available when encoder setting is disabled.Setting Range0.060 to 240.000 m/min (LP-430 / LP-420 / LP-435 / LP-425 / LP-V10 / LP-V15)0.060 to 170.000 m/min (LP-410)0.060 to 120.000 m/min (LP-431 / LP-421 / LP-W052)0.060 to 85.000 m/min (LP-411)3 Encoder SignalEnable this function when using the encoder. The setting parameter for the line speed is disappeared from thescreen and the parameter for encoder pulse number appears instead when pressing the box.When the encoder isnot used: Performs marking to flying object by applying the calculated line speed already input.When the encoder isused: Performs marking to flying object by applying the calculated line speed which is derivedfrom the pulse sent from the encoder input to the input terminal.SensorDelay distanceWork direction5ME-LP400V-OP-6
