181Description6 Bold Line Width :Specifies the width of bold character line.Setting Range0.000 to 2.000 mm (LP-V10 / LP-W052)0.000 to 4.000 mm (LP-431 / LP-421 / LP-411 / LP-V15)0.000 to 6.000 mm (LP-430 / LP-420 / LP-410 / LP-435 / LP-425)Notice• Marking of bold character may affect the quality of marking. Check it by a trial before using this function.Reference• At marking of bold characters, set the values so ratio of character height to character width be within 1/4 to 4.• Set line width of bold character to quarter or below of either smaller one, character height or character width.• When marking the bold character, set the marking pitch in the Laser Condition together. Refer to “4-11 Laser Setting”(P.214).• The Original Font 4 may fail to mark the character in bold.7 Laser Power Correction :Scan Speed Correction :Laser Pulse Cycle Correction (Only LP-V series) :Correction of each character condition No. for the laser power / scan speed / laser pulse cycle set at laser setting.Setting Range of Laser Power Correction 0 to 200%Setting Range of Scan Speed Correction 5 to 500%Setting Range of Laser Pulse Cycle Correction 50 to 200%Reference• If the value of “Laser power correction” × “laser power” is equal to or larger than 100, the setting will be “100”.• Marking is not available when the laser power correction value is “0”.• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.8 Area No. :Displayed when marking on-the-fly is set in “Trigger setting”.It indicates the order of the marking field for the concatenated marking to flying object.Setting Range 0 to 15ME-LP400V-OP-6
