290⿎ Detaching Method of BatteriesIn case of disposal of laser marker in the European Union, remove the battery with the following procedures andsegregate it properly in accordance with the EU Battery Directive (2006/66/EC).WARNING • When detaching the exhausted battery, be sure to disconnect the controllerpower cable so that the power cannot be supplied to the device. There is a riskof electrical shock.Notice• This method is never described with the replacing method of the battery. The customer should call our servicerepresentative to replace the battery.1. Remove the side cover of the controller.Remove 6 screws of the side cover as shown in the figure below, and then slide the cover backward.After removing the cover, the battery is installed in the position as shown in the right figure below (surrounded withcircle).2. Remove the used battery as shown in the figure below.Cut 2 banding bands by using the nipper. Then, remove the connector of the battery, and remove the battery from theboard.BatteryTie BandME-LP400V-OP-6
