1864-10-3 Logo Condition⿎ VEC File Format ⿎ DXF File Format1 23 4678 15141 23 4657911121310 1514Description1 Logo condition No. :Registered No. of logo data to be marked. Max. 16 logo files are settable for per file.Setting Range 0 to 152 File Format :Selects file format from “VEC” or “DXF”.3 Logo File :Displays the logo file set to the specified logo No. The selecting window for logo file is appeared by pressing logofile name. Select the logo file to be marked, and press [EXECUTE].Reference• The max. loadable coordinate is 131,072 points.The number of coordinate points can be checked in “Logo Data Conversion Software”.• Compared to the VEC file, the data amount of the DXF file becomes heavier and its time to be in READY for markingwill be longer.In case of registering much logo data or shortening the time for file change, convert the DXF data into the VEC datausing the attached software “Logo Data Conversion Software”.4 DELETE :Press [DELETE] to delete the setting of the logo file.If there is no logo file setting, the logo condition is not saved at file saving.5 Origin (only for DXF file format) :Specifies the coordinate of the origin point for DXF file data.Select from center, lower left, lower right, upper left, upper right or as original graphic.6 X/Y Position :X/Y position of the reference point of the logo file data.Setting Range -300.000 mm to +300.000 mm7 Rotation Angle :Sets the rotation direction of the logo file data.Setting Range -180.00 to +180.00 degree8 X/Y Mag. (only for VEC file format) :Specifies the magnification of X/Y of the VEC file data.Setting Range 0.100 to 10.000 timesME-LP400V-OP-6
