2000-A2-GB20-10 - 91 - February 2004 Configuring Maintenance Protocol (page 93) Configuring Congestion Parameters (page 93) Enabling or Disabling Coppermountain CMCP (page 94)Selecting Fragmentation TypesTo select which fragmentation to use:1. On the Frame Relay Options menu, type 1 to display the FRFragmentation Configuration menu.Figure 4–61. Frame Relay Fragmentation Configuration Menu2. Do one of the following:a. Type 1 to select Configure FRF.12 Fragmentation—go to FRF.12Configuration, following.—or—b. Type 2 to select CopperMountain Fragmentation—go toCopperMountain Fragmentation Configuration, on page 92.Setting FRF.12 ConfigurationIf you selected FRF.12 Fragmentation, the IAD displays the FRF.12Configuration menu:Figure 4–62. FRF.12 Configuration MenuType the option and proceed to the corresponding section.Enabling or Disabling FRF.121. Type 1 to enable or disable FRF.12.The IAD displays the status and a prompt:FRF.12 Fragmentation is currently DISABLEDEnter E to Enable, D to Disable:Type E to enable End-to-End fragmentation, or type D to disable it.2. The IAD saves the configuration and displays the FR FRF.12Configuration menu. Press Escape to continue.3. Reset the IAD (page 14) when you finish Frame Relay configuration.*****************************************FR Fragmentation Configuration*****************************************1. Configure FRF.12 Fragmentation2. Configure CopperMountain Fragmentation*****************************************FR FRF.12 Configuration*****************************************1. Enable/Disable FRF.122. Enable Automatic Fragment Sizing3. Set Manual Fragment Size
