2000-A2-GB20-10 - 48 - February 2004This chapter describes how to configure the IAD WAN interface anddatalink protocol for data operation. Basic WAN setup tasks (page 48) Using the WAN Configuration menu (page 52) Selecting the Datalink Protocol (page 53) Selecting the Physical Interface (page 55) Configuring the G.SHDSL Interface (page 56) Configuring the SDSL Interface (page 60) Configuring the ADSL Interface (page 64) Setting the Interface to T1 or E1 (page 65) Configuring the T1 Interface (page 66) Configuring the E1 Interface (page 71) Configuring ATM PVCs (page 75) Configuring ATM Options (page 84) Configuring Frame Relay DLCIs (page 86) Configuring Frame Relay Options (page 90) Using the Quick Configure Option (page 95)Basic WANSetupTasksTo set up the IAD for voice and data operation, you must perform at leastthese basic tasks: Select ATM or Frame Relay as the datalink protocol (page 53) For ATM protocol, configure ATM PVCs (page 75) and ATM options(page 84) For Frame Relay protocol, configure Frame Relay DLCIs (page 86)and Configure Frame Relay options (page 90) Configure the WAN interface for your IAD (following) For channelized T1, set up voice and data circuits (page 54) Configure the voice path (Voice Path Configuration on page 127).Use the flowcharts below to plan your tasks for configuring either xDSL orT1/E1 based on your wide area networking requirements.#X6I8svt
hvNOTE When the IAD prompts you for input, it displays the default orcurrent value in parentheses. To conveniently accept thisvalue, just press Enter.