2000-A2-GB20-10 - 105 - February 2004Removing a Static RouteTo delete a static route from the Route Table:1. On the Router Modification menu type R to select Remove a Route.2. The IAD prompts for the address of the route to remove:Enter address of static route to remove:Type the IP address of the route to remove and press Enter.3. The IAD removes the route from the table and the IAD displays theRouter Modification menu.4. Repeat these steps for each route that you want to remove.5. Continue with other configuration tasks, or press Escape to return tothe Main menu.6. Reset the IAD (page 14) when you finish router configuration.Setting theDefaultRouteAdding or Changing the Default RouteTo add a default route on the WAN, or change the current default route:1. On the Router Modification menu type F to select Add/Change theDefault Route.2. The IAD prompts for the default gateway address. (You may press 0for a list of interfaces):Enter Default Gateway address, or 0 to pick anInterface:Type the default gateway address and proceed to step 3.-or-Type 0 to display the port table:Select default IP interface.Port VPI VCI Encapsulation Type PCR Service1 0 40 RFC 1483 (with LLC Encap)3641 UBRTotal = 3641 cpsMaximum PCR this interface can support = 3622 cpsSelect Port: [1-8]Type the port to select and press Enter.3. The default route is set and the Route Table is updated.4. Continue with other configuration tasks, or press Escape to return tothe Router Modification menu.5. Reset the IAD (page 14) when you finish router configuration.Removing the Default RouteTo remove the default route from the Route Table:1. On the Router Modification menu type T to select Remove the DefaultRoute.2. The default route is immediately deleted and the Route Table isupdated.3. Continue with other configuration tasks, or press Escape to return tothe Router Modification menu.4. Reset the IAD (page 14) when you finish router configuration.
