2000-A2-GB20-10 - 182 - February 2004Most options on the Reports menu generate a specific report. However,the Network Statistics, Interface Statistics and Media Statistics optionsdisplay a menu of several related reports and commands to resetaccumulated statistics.To display a report or group of reports, or to clear statistics for a particularprotocol or interface, select the option and proceed to the appropriatesection.CurrentConfigur-ationReportTo display the Current Configuration report, enter C on the Reports menu.The Current Configuration report displays configuration settings andinformation about the installed interfaces on your IAD.For each port on the IAD, details are displayed. For each interfaceconfigured on a port, details are also displayed. The parameters arerepeated, and not described again in the table.The information displayed in the Current Configuration report is listed inTable 12–1. The contents of this report varies, based on the configuration,interfaces and ports on the IAD.NOTE When viewing a report, press any key to display the nextpage, or return to the Reports menu at the end of the report.Press Escape to return to the Reports menu at any time.Table 12–1. Current Configuration ReportParameter DescriptionSoftware version version of IAD firmwareSerial Number serial number of the IADContains # DSP chip(s) no. of DSP chips in the IADRouting Information Protocol Status: enabled | disabled globallyBridging Status: enabled | disabled globallyBridge Database Aging Time 1-3600 seconds (default 300 seconds)Spanning Tree enabled | disabled globallySpanning Tree bridge priority 1-65,535 (default 32,768)Spanning Tree hello time 1-10 seconds (default 2 seconds)Spanning Tree max age 6-40 seconds (default 20 seconds)Spanning Tree forward delay 4-30 seconds (default 15 seconds)Simple Network ManagementProtocol (SNMP) (IP and EOC)Status: enabled | disabledSNMP System Contact user-defined (maximum 39 characters)SNMP System Name user-defined (maximum 39 characters)SNMP System Location user-defined (maximum 39 characters)SNMP Community name must match the SNMP host (maximum =39 alphanumeric characters); If SNMP isenabled and the SNMP Community Name isnull, SNMP goes into read-only mode.SNMP Trap Host IP Address IP address of the SNMP trap hostMulticasting Status: enabled | disabled
