2000-A2-GB20-10 - 138 - February 2004When you select a specific country mode, the values are set automatically:Figure 7–11. Country Mode Selection Menu1. Type the letter corresponding to the country mode you want to set.2. The IAD saves the mode you’ve selected and displays the menu.3. Press Escape to return to the Voice Configuration menu and continuewith other voice path configuration.4. Reset the IAD (page 14) when you finish voice path configuration.ManagingMGCPEmbeddedClientThis section applies to MGCP—Voice Over IP—gateway management.To configure or manage MGCP/NCS, type O to display the MGCPManagement menu:LAN LINK LAN ACT WAN LINK VOICEPOWERJF2008JF2104JF2108Ring frequency and impedance settings are automaticallyapplied to the JF2008, JF2104 and JF2108.*******************************************Country Mode Selection*******************************************Current Country Name is ETSI GenericCurrent Country Mode is EuropeA. Australia Complex ImpedanceB. ETSI GenericC. United States of AmericaNOTE To add support for any of the countries/regions listed abovebut not displayed in the Country Mode Selection menu,contact your service provider to obtain the file.NOTE The IAD only displays option O, Manage MGCP EmbeddedClient on the Main menu if you selected Voice Over IP viaMGCP 0.1/NCS 1.0 or MGCP 1.0 as the Voice Gateway.