2000-A2-GB20-10 - 53 - February 2004Selectingthe DatalinkProtocolIf you are setting up voice and data channels, you can select ATM orFrame Relay as you set up the channels, in the section Setting Up TDMVoice, following.To select ATM or Frame Relay as the datalink protocol:1. On the WAN Configuration menu, type 1 to select Configure DatalinkProtocol.2. The IAD displays the WAN Datalink Protocol Configuration menu,identifying the current datalink protocol just below the banner.Figure 4–4. WAN Datalink Protocol Configuration MenuSelecting ATM or Frame RelayWhen you select ATM as the datalink protocol, the IAD displays the ATMand PVC options on the WAN Configuration menu:Figure 4–5. WAN Configuration Menu (ATM)When you select Frame Relay, the IAD displays the Frame Relay optionson the WAN Configuration menu:NOTE You must sign on as Supervisor to configure the WANinterface.Be sure to reset the IAD when you are done making changesto WAN settings. Resetting the IAD causes the configurationchanges to take effect.*********************************************WAN Datalink Protocol Configuration Menu*********************************************Current DataLink Protocol: Frame Relay6. ATM7. Frame RelayLAN LINK LAN ACT WAN LINK VOICEPOWERJF2000JF2100JF2000 and JF2100 series IADs do not support Frame Relay.*****************************************WAN Configuration Menu*****************************************Configuring G2237 xDSL1. Configure Datalink Protocol2. Configure Physical Interface3. Configure PVCs4. Configure ATM OptionsOptions 3 and 4display ATMconfiguration options