2000-A2-GB20-10 - 103 - February 20045. Setting the RIP version for this port is complete. The IAD saves thesettings and displays the Router Configuration menu.6. Repeat these steps for each remaining port to set.7. Continue with other configuration tasks, or press Escape to return tothe Main menu.8. Reset the IAD (page 14) when you finish router configuration.ManagingStatic andDefaultRoutesTo create, update and delete static and default routes, type S on theRouter Configuration menu. The IAD displays the Router Modificationmenu, which contains commands to manage the IAD’s route table:Figure 5–3. Router Modification MenuThe tasks in this section originate at the Router Modification menu. Typethe option to perform a task and proceed to the corresponding section.Adding a Static RouteTo add a static route to the Route Table:1. On the Router Modification menu type A to select Add a Static Route.2. The IAD prompts for the destination address:Enter destination address of route to add:Type the destination address to add and press Enter.3. The IAD displays the current subnet mask and prompt:Enter network mask of route:(255.255.255.0) ->Type the network mask and press Enter.4. The IAD prompts for the gateway address:Enter gateway of route:Type the gateway address, press Enter.5. The static route is added. The IAD prompts for confirmation:Route successfully added.Save this route in the static configuration (Y)?6. Type Y to confirm, or Escape to cancel.If you confirm, the Route Table is updated and the IAD prompts to addmore routes:Add another route (Y)?7. Type Y to confirm, or Escape to cancel.8. Repeat these steps for each route that you want to add.*******************************************Router Modification Menu*******************************************A. Add a Static RouteR. Remove a RouteF. Add/Change the Default RouteT. Remove the Default RouteD. Display Route Table