2000-A2-GB20-10 - 52 - February 2004Using theWAN Con-figurationMenuConfiguring the IAD for data involves several tasks. Tasks in this chapterare described beginning at the WAN Configuration menu (which varies,based on the WAN interface and datalink protocol).Figure 4–3. WAN Configuration Menu6300LAN LINK LAN ACT WAN LINK VOICEPOWERJF2304JF2308JF2316SDSL with Frame Relay1. Set the datalink protocol to Frame Relay (page 53)2. Configure SDSL (page 64)3. Configure DLCIs (page 86)4. Configure Frame Relay options (page 90)5. Configure the voice path (page 127)SDSL with ATM1. Set the datalink protocol to ATM (page 53)2. Configure SDSL (page 64)3. Configure PVCs (page 75)4. Configure ATM (page 84)5. Configure the voice path (page 127)LAN LINK LAN ACT WAN LINK VOICEPOWERJF2304 To configure the physical interface of the IADs, you may alsouse the Quick Configuration command. For more information,see Quick Configuration on page 95.LAN LINK LAN ACT WAN LINK VOICEPOWERJF2104JF2104iJF2108G.SHDSL with ATM1. Set the datalink protocol to ATM (page 53)2. Configure G.SHDSL (page 64)3. Configure PVCs (page 75)4. Configure ATM (page 84)5. Configure the voice path (page 127)SDSL with ATM1. Set the datalink protocol to ATM (page 54)2. Configure SDSL (page 64)3. Configure PVCs (page 75)4. Configure ATM (page 84)5. Configure the voice path (page 127)**************************************WAN Configuration Menu**************************************Configuring T1/E11. Configure Datalink Protocol2. Configure Physical Interface3. Configure DLCIs4. Configure FR OptionsThe IAD displaysthe physicalinterface in thisstatus message.These options change,based on your choiceof datalink protocol