2000-A2-GB20-10 - 206 - February 2004Frame Relay Statistics ReportType F to display the Frame Relay Statistics report. This report displaysbasic about Frame Relay operations on the WAN link (for all ports andDLCIs).Table 12–18.Frame Relay Statistics ReportParameter DescriptionReceived DataRx Frames No. of frames receivedRx Bytes No. of total bytes receivedRx Frames discarded No. of Frame Relay received packets discardeddue to:- Received Frames are larger than size of PDU- Received Frames Headers are smaller than thestandard HDLC header size.- Validity of address bits settings in the HDLCheader is incorrect.- Value of Checksum Field in header is incorrect.- The received DLCI number does not match theDLCI connections on the IAD.DE set on Rx Indicates Discard Eligibility is allowed on incomingframes, based on congestion, to maintaincommitted information rate.FECN set on Rx Forward Explicit Congestion Notification status setto notify DTE that congestion avoidance should beinitiated by IAD.BECN set on Rx Backward Explicit Congestion Notification statusset to notify DTE that congestion avoidance shouldbe initiated by the sending device.Rx congestion counter No. of frames dropped due to congestion tomaintain committed information rate.CLLM frames Rx No. of CLLM (Consolidated Link LayerManagement) frames receivedLMI frames Rx No. of LMI (Local Management Interface) framesreceivedANSI frames Rx No. of ANSI frames receivedTransmitted DataTx Frames No. of frames transmittedTx Bytes No. of total bytes transmittedTx Frames discarded No. of Frame Relay packets discarded due to:- Transmitted frames are larger than PDU size.- Packets overflow.DE set on Tx Indicates Discard Eligibility is allowed ontransmitted frames, based on congestion, tomaintain committed information rate.FECN set on Tx Forward Explicit Congestion Notification status setto notify DTE that congestion avoidance should beinitiated by IAD.BECN set on Tx Backward Explicit Congestion Notification statusset to notify DTE that congestion avoidance shouldbe initiated by the sending device.
