2000-A2-GB20-10 - 47 - February 20042. Type 1, 2, or 3 to enable or disable specific derived timing debuggingmessages.For each option, the IAD displays the Derived Timing Debug menu.2. Type 1 to enable debug messages, or 2 to disable debug messages.3. Reset the IAD (page 14).Verifyingan IPAddressWhen operating the IAD in a network, there are several different IPaddresses you should be aware of: One for a computer running Windows. One or more for the IAD.Verifying an IP Address for Windows SystemsTo verify the IP address of your computer:1. Click the Start button, click Settings and then click Control Panel.2. In the Control Panels window, double-click the Network icon and thenclick the Configuration tab.3. In “The following network components are installed” list, click TCP/IPand then click Properties.4. Click the IP Address tab and note the IP address.In Microsoft Windows 95 and 98, you can run winipcfg at the commandprompt to verify the IP address of your computer. In Windows Me, 2000, orXP, use ipconfig.Verifying the IAD IP AddressesTo verify the IP address of the IAD:1. On the Main menu, type R to select the Reports menu.2. Type C to select Display Current Configuration.3. Note the IP addresses for the Ethernet and WAN Interfaces.*****************************************Reports Menu*****************************************C. Display Current ConfigurationN. Display Network StatisticsI. Display Interface StatisticsM. Display Media StatisticsR. Display Route TableA. Display ARP TableB. Display Bridge Forwarding DatabaseS. Display Bridge StatusP. Display PPP Authorization EntriesU. Display System UptimeO. Display Memory StatisticZ. Zero All Statistics
