2000-A2-GB20-10 - 132 - February 2004SettingSLIC Con-trol ModeTo set SLIC control mode (for POTS only), type T to display the SLICControl Mode Selection menu:Figure 7–5. SLIC Control Mode Selection MenuType the option of the control mode to set.1. The IAD saves the mode you’ve selected and displays the menu.2. Press Escape to return to the Voice Configuration menu and continuewith other voice path configuration.3. Reset the IAD (page 14) when you finish voice path configuration.SettingCom-panderModeTo set Compander Mode, type U to display the Compander ModeSelection menu:Figure 7–6. Start Mode Selection Menu1. Type the option of the Compander mode to set.2. The IAD saves the mode you’ve selected and displays the menu.3. Press Escape to return to the Voice Configuration menu and continuewith other voice path configuration.4. Reset the IAD (page 14) when you finish voice path configuration.*******************************************SLIC Control Mode Selection*******************************************Current Control Mode = AUTO Control ModeA. AUTO Control ModeB. MANUAL Control ModeNOTE Voice gateway applications, such as CopperCom orJetStream, overrides the value set by this command.*******************************************Compander Mode Selection*******************************************Current Compander Mode = u-LawU. u-Law ModeA. A-Law ModeNOTE If you are unsure which mode to use, check with yourtelephone service provider. Normally, u-Law is used in NorthAmerica and a-Law is used in Europe.
