2000-A2-GB20-10 - 102 - February 20041. Type P on the Router Configuration menu to select Configure RIPPoisoned Reverse by Port.2. The IAD displays the interfaces on this IAD (sample shown):Available Interfaces:1. SDSL2. 10/100BaseT Ethernet0. (Abort)Type the number of the port to enable or disable.3. The IAD displays the RIP status of this port and a prompt:RIP Poisoned Reverse for Slot 1, Port 1 is currentlyDISABLEDEnter E to Enable, D to Disable:Type E to enable RIP Poisoned Reverse, or type D to disable it.4. The IAD saves the configuration, and displays the RouterConfiguration menu.5. Repeat these steps for each port for which you want to enable RIPpoisoned reverse.6. Continue with other configuration tasks, or press Escape to return tothe Main menu.7. Reset the IAD (page 14) when you finish router configuration.Setting the RIP VersionTo set the RIP version:1. Type V on the Router Configuration menu to select Configure RIPVersion by Port.2. If more than one WAN port is installed or more than one PVC/DLCIexists, the IAD displays the interfaces on this IAD (sample shown):Available Interfaces:1. SDSL2. 10/100BaseT Ethernet0. (Abort)Type the interface number to set.3. The IAD displays the port table for this interface and prompts for a port:Port VPI VCI Encapsulation Type PCR Service1 0 40 RFC 1483 (with LLC Encap)3641 UBRTotal = 3641 cpsMaximum PCR this interface can support = 3622 cpsSelect Port: [1-8]Type the port to set and press Enter.4. The IAD displays the RIP configuration and status of the slot and portyou’re setting, and prompts for a new version:Current RIP configuration for Slot 1, Port 1 isDisabledEnter RIP Version for Port 10. Disabled1. Version 1 Broadcast2. Version 2 Broadcast3. Version 2 MulticastType the option number of the version to set.
